I acknowledge that the product(s) being purchased () was/were designed and intended for closed course competition use only. The product(s) is/are neither designed nor intended for use on public roads or land and is against Federal and State regulations to do so. By proceeding with this purchase, I , agree to only use the product(s) for closed course competition.
Tired of the OEM fender on the 2017-2020 Yamaha R6? We are, too. That's why developed a sleek and clean solution that transforms your tail section with high-quality components that don't break the bank. Our Elite-1 Fender Eliminator is available in a stainless steel fixed-position bracket, or an adjustable CNC machined aluminum bracket that enables more customization and mounting options.
Want to upgrade your OEM signals? Check out our LED Rear Pod Signal Kit for a bright and modern solution guaranteed to work with this Elite-1 Fender Eliminator.
Applications:
Yamaha YZF-R6 | 2017, 2018, 2019, 2020
Click to Show Products ▼
Features
DescriptionOur exclusive Elite-1 Fender Eliminator and Closeout for the 2017-2020 Yamaha YZF-R6 is available in a fixed or an adjustable bracket option. The fixed bracket offers a budget-friendly solution with high-quality material, while the adjustable bracket enables both high and low mounting options and plate angle customization. Each kit includes a CNC machined undertail closeout that features a durable black anodized finish and fills in the hole from removing the stock fender while offering a mounting position for either the Fixed or Adjustable license plate bracket. It features wire routes that enable you to run signal and license plate lighting wires discreetly through the undertail and into your subtray, or you can close it off with included stainless steel counter-sunk hardware for a flush and sleek look. This kit enables you ditch that bulky, beast of a fender that comes stock on your new R6 and install a sleek and versatile fender eliminator that saves weight and drastically improves the tail design. PLEASE NOTE: The Lower Mounting location is ONLY possible with the Adjustable Mounting Bracket. NON U.S. BUYERS: Our fixed bracket is designed for U.S. plates and fits a hole spacing of 5 to 6.1 inches with 5mm hardware, while the adjustable bracket fits a hole spacing of 5.2 to 6.29 inches with 5mm hardware. It is your responsibility to verify fitment before making your purchase. Please note this item is not DOT approved and may not comply with the laws and regulations in your area. See our Terms & Conditions for more information. Standard Kit
Adjustable Kit
Installation instructions located here. Step-by-step video tutorials located in the Videos tab. Standard Setup InstallationAdjustable Setup InstallationOEM Signal Bracket Installation |
WARNING: Cancer and Reproductive Harm - www.p65warnings.ca.gov