Motion Pro Universal Handlebar Stop/Start Switch

Features

• Designed to work with the Motion Pro Rev2 Variable Rate Throttle Kit
• Slim design takes up less space on the handlebar
• Fits 7/8" (22.2mm) handlebars
• Stainless steel screws and rubber internal pad ensures secure mounting
• Push In/Out engine switch design
• Momentary 2 pole starter switch
• Starter switch has 2 separate circuits, one normally open, one normally closed for street bikes that use a headlight/starter cutoff
• 550 mm long wiring harness with brake light switch circuit wiring
• Brake light circuit wiring pigtail 120 mm long with female spade connectors
• Wire harness features bare, tinned wires without connector for easy installation of OE connector body

Description

Some motorcycle throttle housings are encased in the same plastic clamshell housing as the electronic start/stop switch, but when upgrading your bike with the Motion Pro Rev2 Variate Rate Throttle Kit, the throttle housing and electric switchs must be separate. Motion Pro made this an easy fix with their universal Stop/Start electronic switch so you can get back on the road and enjoy the new Rev2 throttle kit faster. The extra narrow 26mm slim design won't take up too much room on your 7/8" (22.2mm) handlebar and features a push In/Out engine switch. The included stainless hardware and rubber pad ensure that the switch assembly stays put after installed while the ample wire length and bare tinned wires provide easy connections for installing the OE connector plug.