Do not buy this product or risk engine damage.

I am a millwright so I understand on how the physics work for bolt yield.

One of the bolts supplied is not the correct length and due to improper thread engagement a hole for my engine mount on the engine block had its threads stripped out before reaching torque spec. This bolt bottomed out on the frame sliders counterbore before it bottomed out on the first thread in the hole which was the first indication something was not correct with the supplied bolt sizes.

I contacted TST for them to only deny any possibility of something being wrong with their product and after a few emails finally sent me what should be the correct bolt length. However while it was the correct length of bolt they sent the wrong size.

This company is grossly incompetent and due to the fact this bolt has such uncommon specifications my local area does not have any in stock so now I am just riding around with one frame slider missing.


~~~~~TST Industries Response~~~~~
We are not the designers or manufacturers of this kit. This kit is from Womet-Tech and any design comments or suggestions should be made to the manufacturer.

Quality, value and brighter than stock.

Advantages: Easy to install. Get the RELAY. Safety, especially when combined with set of turn signals. Best looking unit on the market. Sequential blinkers, sweet.

Disadvantages: None

This tail light has been great I've had it on my bike for a couple years now and I love it. This company has also been amazing to order threw customer service is the best highly recommend.

worked on BMW G650GS Sertao. The connector was a fit but it could not be attached to the original holder of the old relay. I wrapped it into a small rag and put it loose on top of the other relays. Works fine so far.

Looks good, was quick and easy to install. I would recommend.

Advantages: Slim and looks good.

Disadvantages: n/a

Clean. Easy to install. Must have for all Ninja owners. Get the license plate bracket and the integrated taillight as well, u wont regret. I grabbed a set of blinkers for extra safety from behind. Just looks so clean now.

Advantages: Affordable. Quality. East to install. Lightweight.

Disadvantages: None.

Plate kit 3 works for rear signals on a Suzuki DRZ400S. The parts form a plastic bubble that is compressed when the turn signal nut is tightened.

Advantages: My LED turn signals are very small and light so this _might_ provide a sufficiently secure mount.

Disadvantages: Some concern about over tightening signal mounting bolt. Some concern that mount might not be sufficiently robust for trail riding.

These make the FZ-09 look really sharp compared to the original equipment up front. Just installed a few days ago but so far so good. Easy install. I was able to use the rubber that filled in the underside of the front trim to seal it back up contrary to what the video said.

Advantages: Slim, clean look. Bright. Work great

Disadvantages: Feel the mounting could be a little cleaner. Modified it to utilize the original rubber to seal up the gaps

Very easy to assemble with easy to follow instructions along with a good video on installation on YouTube. I had trouble with my first light where it wasn’t sealed properly and it created water damage and caused a few leds to go out but upon contacting tst I had a replacement sent to me

Advantages: Low profile really cleans up the look of the bike compared to the stock bulky assembly

Disadvantages: I use my drz400sm off roading and unfortunately since the light is so tucked away into the fender I had my tire fling a rock up and smash a hole into my light Also it’s hard to see the turn signals on the intergraded tail light

This looks amazing on my new MT-03. Super easy to install.

Advantages: Looks factory
Easy to install

Disadvantages: none