TST Elite-1 Fender Eliminator Kawasaki 2013-2017 Ninja 300

I bought this along with the integrated tail light. It seemed as though everything was going ok and not taking too long to get through the disassembly of the motorcycle. I was working on putting this fender eliminator together and found that the screw did not want to go into the mount that the license plate pivots on. I was able to get the screw to go in from one side, but not the other. I had the exact same experience with both pivot points. Because I do not own an tap and die set and I didn't want to put the motorcycle back together and try to send the kit back for replacement, I set about to try to make it work. I was able to hold the pivot bracket in some pliers and work the screw through from the other side until I was able to force past whatever the problem was. Eventually, after quite a while, I was able to get the screw to go in properly. I highly recommend you attempt to put the bracket together before you take your motorcycle apart so that you will know if there will be any problems.

I also ordered the stealth license plate light kit to go with this. Because I still have the paper plate from the dealer, I left the plastic dealer plate frame on it for additional support. With the frame on it, the stealth light is all the way up against the bottom of the motorcycle which makes it so that I am unable to adjust the angle of the plate. Maybe when I get the actual plate and remove the frame it will pivot properly. Keep this in mind if you want to use a decorative plate frame.

Then there is the close out that covers the old screw holes. It looks nice, but I don't understand the high cost of that little piece of metal.

Overall I think that the price of this Elite-1 Fender Eliminator it a little too high and maybe there need to be a few kinks worked out of it.