TST Elite-1 Fender Eliminator and Undertail Kit for Yamaha R3 2015+ / MT-03 2020+

The bracket for the license plate is fine, however the turn signal mount is terrible. The video showed no installation process and there is no hole to thread the wires inside the bike to connect them. There needs to be a hole so you can put the turn signal lights through the rear fender and actually connect them.



~~~~~TST Industries Response~~~~~
Our undertail has a pilot hole marking where customers are instructed to drill a hole of the necessary size in order to route wiring.

Advantages: Actual license plate bracket is great.

Disadvantages: Turn signal mount is terrible and needs revision alongside instructions in the video.

Looks very clean on the bike. Installation was a bit of a hassle. The adjustable kit has so many pieces that can rotate, getting everything lined up can be difficult. After getting it installed, the pieces the arms mount to are not parallel, so adjusting the angle of the plate only works for a very limited range. The installation video states they should be parallel and point straight towards the back of the bike, but mine do not do that. Perhaps I got a bad kit where the L brackets off the license plate bracket are not bent correctly or something, but it made things very tough to line up. Kind of wish I would've gone with the non-adjustable version because of this... Given that the point of the adjustable kit is to be adjustable, that weighs heavily into my score.

Advantages: Matches look of the bike
Well priced

Disadvantages: Parts did not line up well, so adjusting the plate angle doesn't work properly

You have to drill a hole if your want lights. For as much as it is you shouldn’t have to drill a hole. The adjustable bracket isn’t easily adjustable. I was under the impression you would be able to adjust it and it’ll stay as it kind of like a ratcheting system. Instead you have to loosen some bolts, set it to how you want, and then tighten it. Not worth the extra money. On the plus side it matches very well with the oem shape.

Good if you don't get the adjustable kit. So many screws and moving parts to deal with and adjusting to get it right.

Advantages: Nice and tidy.

Disadvantages: Too many screws to contend with.

The fender eliminator its ok but the license plate adapter wont fit very well on my yamaha MT03. The license plate of my country fit near the tire. I pass trought a bump and broke my license plate. Its a license plate very big. If you buy for this bike, buy the adjustable.