Womet-Tech Frame Sliders for Yamaha R3 2015-2018 / MT-03 2020+

I was obviously skeptical about doing the cut-type frame sliders, but after watching the installation video, it looked doable. The install went perfectly. I followed the steps exactly as shown on the video and had no issues. The template was a perfect fit. Notes: 1) I made a copy of the template in case i screwed up the cut and needed to try again.
2) The hole saw on the left fairing cut butts up against the main mounting point, which made me nervous, but it worked out.
3) I took my time with the clean up of the holes, with a couple of test fits.
4) If you are going to do flush mount signals, I would advise to do them at the same time to save the hassle of removing the fairings a second time.

Advantages: Low cost, low profile so knees won't hit, very nice clean look, color matching inserts.

Disadvantages: Not sure if you can order replacement sliders if you want to replace as scratched one.

######### TST INDUSTRIES MESSAGE ##########
Hi Sean, if you ever need a replacement slider puck, shoot us a message and we can get you taken care of right away!

Easy install on an MT-03 - no fairings to cut! Follow along with the video install if you’re unsure of anything! Only do one side at a time to prevent the motor from dropping/twisting. Use loctite and torque to spec. Makes for a little footrest when cruising!

For anyone reading this, this fits SEA (asean) mt25 perfectly, due to the fact that mt03 is also produced in the same factory.

Advantages: Overall great build, solid slide surface (a lot better than my $70 axle slider i bought from other brand) and easy to install.

Disadvantages: Would be great if we have other colored spacer, the silver is a bit crashing with my (nearly) all black-red bike