I acknowledge that the product(s) being purchased () was/were designed and intended for closed course competition use only. The product(s) is/are neither designed nor intended for use on public roads or land and is against Federal and State regulations to do so. By proceeding with this purchase, I , agree to only use the product(s) for closed course competition.
This relay will fix your flash rate problem caused by aftermarket signal lights and/or integrated tail light. If your signal lights flash too fast or do not flash, this part is your solution! Plug and play - easy installation.
What's included:
Applications: PLEASE CHECK APPLICATIONS TAB
Only ONE relay is needed per motorcycle.
Tech Tip Episode Explaining Relays and ResistorsProduct Features and HighlightsFeatures
This component works with the following signal configurations:
PLEASE NOTE: The relay comes preset to 85 cycles per minute. You can alter the flash rate to make it faster or slower. If you slip off the grey cover you can access an adjuster that will enable you to change the flash rate to your liking. This relay enables the signals to be active / activated when the bike is turned off, so please ensure that your signals are properly turned off when parking or storing your bike to prevent unnecessary battery drain. INTERNATIONAL BUYERS: Please make sure your bike uses a relay with a connector style as shown above for the signaling system. Please also note the pin configuration and make sure it matches what is on your bike. IT IS YOUR RESPONSIBILITY TO VERIFY FITMENT BEFORE MAKING YOUR PURCHASE. American Applications
European Applications
InstallationFlash Rate Adjustment Instructions |
WARNING: Cancer and Reproductive Harm - www.p65warnings.ca.gov